You want to add more than two parallel AND (or XOR) Steps to a workflow but it's not supported in the GUI.
This is a limitation of the GUI in CQ 5.2 only, the CQ5Workflow engine itself has no restrictions in the number of parallel AND (or XOR) Steps.
Resolution / Workaround
You can create the corresponding Nodes in CRX directly.
A workflow in CQ5 contains Nodes for the Steps in
/etc/workflow/<your workflow>/nodes and for the Transitions in
Every workflow Step is connected by a Transition with another Step.
To add for example a third parallel AND (or XOR) Step in an existing workflow with two parallel AND (or XOR) Steps you have to add one additional Node for the Step and two Nodes for the Transitions from the AND-Split (or XOR-Split) to the Step and from the Step to the AND-Join (or XOR-Join).
You have a workflow with following Steps:
- Step 1 (above AND)
- Step 2 left
- Step 2 right
- Step 3 (below AND)
The Steps, the AND-Split and AND-Join are stored as Nodes in
- Start - node0
- Step 1 (above AND) - node1
- AND-Split - node4
- Step 2 left - node5
- Step 2 right - node6
- AND-Join - node3
- Step 3 (below AND) - node7
- End - node2
The Traisitions are stored as Nodes in
- node4#node5 - from=node4 (AND-Split), to=node5 (Step 2 left)
- node5#node3 - from=node5 (Step 2 left), to=node3 (AND-Join)
- node0#node1 - from=node0 (Start), to=node1 (Step 1)
- node1#node4 - from=node1 (Step 1), to=node4 (AND-Split)
- node3#node7 - from=node3 (AND-Join), to=node7 (Step 3)
- node7#node2 - from=node7 (Step 3), to=node2 (End)
- node4#node6 - from=node4 (AND-Split), to=node6 (Step 2 right)
- node6#node3 - from=node6 (Step 2 right), to=node3 (AND-Join)
To add a third parallel AND Step you have to add a Node node8 in
/etc/workflow/<your workflow>/nodes and two Nodes node4#node8 (with properties 'from=node4' and 'to=node8') and node8#node3 (with properties 'from=node8' and 'to=node3') in
Note: This third parallel AND Step is not visible in the GUI, but in the inbox of course...
CQ5.2 and CQ5.2.1