When Reader X and Acrobat X are installed on the same machine, or earlier versions of Acrobat already exist, you can choose which viewer is the default for PDF files. While Acrobat is the more capable, feature-rich application, Reader X has a built-in Protected Mode, which is more secure. (For security details, see the Application Security Guide.)
This feature is an Adobe PDF handler-only feature: It does not enable switching to and from non-Adobe products and may or may not change the handling of other Acrobat-supported formats; for example, it changes FDF and XDP, but not XFA or PDX.
Note: This document describes the default behavior users see at installation and runtime. For enterprise configuration, see Administrator and IT resources below.
Reader X introduces the concept of a Protected Mode, which is a general-purpose mitigation against security exploits. This capability does not exist in Acrobat X. Reader X is considered to be far more secure, while Acrobat remains far more capable. Consequently, users have valid reasons to switch between Acrobat and Reader regularly.
For 9.x products, double-clicking a PDF file causes any open instance of the product to load the file regardless of version or product. For example, if Reader X is the default PDF handler and Viewer 9 is already open, double-clicking a PDF opens the PDF in Reader X. Since both Acrobat and Reader can now run at the same time, double-clicking can launch a new process or attach to a running process depending on the machine's configuration. For security reasons, the user needs control over which application opens a PDF; thus X version products provide users with the capability of selecting which product opens the PDF even if another instance is already running.
Version X products can switch between any product type and version back to 9.x and later.
If an existing product is detected during installation, the user is prompted to select the default viewer. For Reader X installations, the default is to make the more secure Reader the default viewer. Regardless of the selection, users can change the default viewer after installation at any time. In general, the installer leans toward letting the more secure Reader be the default viewer unless a property or user choice overrides that decision.
You can change the default viewer by doing the following:
In the Application Startup panel, choose Select Default PDF Handler. Changing the default PDF viewer requires administrator privileges; therefore, OS-specific behavior is as follows:
Pick an application from the drop-down list. The current default appears at the top of the list.
The button may be disabled for two reasons:
You have selected another viewer as the default. For example, your Reader preference is dimmed if Acrobat.exe is the default handler.
No. The Select Adobe Product field only lists products 9.x and later.
For configuration details, admins should refer to the following documents available from the Enterprise Library for the Acrobat Family of Products:
By default, users can select the default handler through the UI. However, administrators can lock the feature via HKLM\SOFTWARE\Policies\Adobe\<product>\<version>\FeatureLockDown\bDisablePDFHandlerSwitching. When bDisablePDFHandlerSwitching is set to 1, the UI is disabled and users cannot change the default handler.